Samenvatting

This paper presents a steady aeroelastic simulation of a 3D Printed propeller blade designed for a High Altitude Platform Station (HAPS) by using the Fluid-Structure Interaction (FSI) method. On the fluid side, steady RANS simulations are carried out in ANSYS Fluent at an altitude of 16 km using the spring-based smoothing method to update the mesh. On the structure side, three materials are used to model the blade structure: two 3D-printed materials which are tough PLA and Onyx to print the blade core which is covered by a composite layer, and an aluminum blade as a benchmark. In order to model the 3D printed materials in ANSYS Mechanical, experimental tensile and bending tests have been performed first on dedicated samples according to the relevant standards. The experimentally fed material models are then used to perform tensile simulations on representative blade sections which are in turn compared to experimental tensile tests in order to validate the numerical approach. After several FSI-iterations, the aerodynamic performance of the rigid and the deformed blades are compared. It is found that the thrust and the torque generated by the deformed blades (FSI) are greater than those generated by the rigid blade (CFD only) for all materials. Also, the blade efficiency is impacted positively or negatively depending on the operating point.
Originele taal-2English
TitelProceedings of the AIAA AVIATION 2021 FORUM
UitgeverijAIAA
Aantal pagina's16
DOI's
StatusPublished - 28 jul 2021
EvenementAIAA Aviation 2021 Forum - online
Duur: 2 aug 20216 aug 2021
https://www.aiaa.org/aviation

Conference

ConferenceAIAA Aviation 2021 Forum
Periode2/08/216/08/21
Internet adres

Vingerafdruk

Duik in de onderzoeksthema's van 'Aeroelastic Response Simulation of a 3D Printed High Altitude Propeller'. Samen vormen ze een unieke vingerafdruk.

Citeer dit